5/ Configuration - DELTA DORE Pack TYBOX 5000 Installation Instructions Manual

5/ Configuration

This menu is used to determine all the settings adapted to your installation.
❶To enter configuration mode, press the MODE button for 10 seconds until the
screen displays CF01.
❷Press + or - to set.
❸Briefly press MODE to go to the next menu.
Press MODE or wait 5 seconds to exit.
CF01 - Correcting the temperature measured
Setting from -5°C to +5°C
Example: If the temperature displayed by the unit is 15°C and the actual
temperature (thermometer) is 16°C, set +1°C.
CF02 - Settings lock
0 No locking (default setting)
1 Total locking
2 Partial locking. Modification of the temperature setting at +/-2°C
The screen will display '____' if it is locked
To unlock (selection 1 and 2), simultaneously press + or - the buttons for 10
seconds.
CF04 - Frost protection mode temperature setting
Setting of 5°C to 15°C. Default value: 10°C.
10
CF05 - Type of temperature displayed in AUTO mode
0 Temperature setting display (default selection)
1 Display of the measured room temperature.
1: Pressing the + or - button once displays and sets the temperature setting (in ON
mode).
CF06 - Regulation time base
15 15 minutes (default settings)
30 30 minutes
45 45 minutes
60 60 minutes
On/Off On/Off
CF07 - Modification of the on/off regulation hysteresis
Only displayed if menu CF06 = on/off
Setting of 0.2°C to 2°C. Default value: 0.4°C
CF08 - Anti-seize function
The Anti-seize function activates the circulator 1 minute per day to prevent any
seizing up during a non-heating period.
0 Anti-seize disabled
1 Anti-seize enabled (default settings)
EN
11