Lcd Contrast; Info; Usb/Imp-Bridge - IMKO SONO-VIEW Manual

4.3.4 LCD Contrast

A bar containing a grey colour gradation will appear.

4.3.5 Info

4.3.6 USB/IMP-Bridge

As soon as this menu item is called up, the SONO-VIEW changes into a transparent data mode. All data packets will
be now redirected from the USB interface directly on to the IMP-bus and vice versa. This enables a comfortable
configuration of the probes via a connected PC without the necessity of additional hardware.
For this purpose, please download the free software „SonoConfig"as well as the respective operating instructions
available on the IMKO-homepage www.imko.de/en.
Connect the SONO-VIEW to the PC using the provided USB cable. The SONO-VIEW will connect with the PC as
a virtual serial interface (COM-Port). The respectively required driver is usually automatically installed by all
currently used Windows versions. Should the driver not be automatically installed, please download the driver
under: http://www.ftdichip.com/Drivers/VCP.htm.
Set the contrast using the buttons
that enables you to recognise all grades.
Store the set value with the button
To exit the menu item „LCD Contrast", actuate the
button .
The device show the serial number, the HW- version, the
IBT version, as well as the firmware version.
By press the button
status information such as the currently connected
probes and system voltage values.
To exit the menu item „Info", actuate the button
/ in a manner
.
the device will present further
.
11