EKKO EK20R Service Manual page 39

CURTIS Contents of hand held unit menu:
The Curtis 1313 hand held programmer is used to configure the Curtis electric control system.Through
this programmer, you can adjust and save the set parameters, real-time monitoring of controller data and
fault
The programmer has two interfaces, one is used to communicate with the electric control, the other is
used to communicate with the PC, the programmer has a battery box and a memory card slot
The programmer is powered on
The connection line of the hand held programmer can be connected to the controller by inserting the
programming port of the controller. After connecting the controller, the hand held programmer will be powered
on automatically and the control information will be displayed on the programmer.
Warning: The control system can affect the vehicle's
diagnosis
acceleration rate, deceleration rate, hydraulic system
and braking. A dangerous situation can occur if the
vehicle control system is not programmed correctly
or exceeds safety. Only the vehicle manufacturer or an
authorized service agent can program the control
system
37