Drive Module For Flat Mounting (Option +C173) - ABB ACS880-04 Hardware Manual

Drive module for flat mounting (option +C173)

￭
Front view of an assembled drive module for flat mounting is shown below. Option
+C173 adds flat mounting brackets to the standard drive module configuration. Option
+0H354 replaces the normal pedestal with a low pedestal. Option +0P919 removes
the installation ramp. You must cut the lower part of the output cabling clear plastic
shroud off when the low pedestal is in use.
1
1
4
Flat mounting position (front view)
1 Flat mounting bracket (two pcs). The brackets
are installed to the mounting plate with 2×8
screws. Four combi screws for installing the
drive module to the brackets are included in
the delivery.
2 External control unit with control panel holder
and control panel
3 Bottom grille to be installed to the base of the
drive module for IP20 degree of protection
See section Standard drive module configuration with option +E208 (page 33)
Operation principle and hardware description 35
2
4 Low pedestal
5 Grounding terminal for output cabling
6 Bottom clear plastic shroud with low pedestal
5
6
Side view
for the part descriptions.