Table of Contents
Advertisement
Chapter 4
Installing Monitor Shelf
This Monitor Rack Mount Kit accomodates all 15"-19"
HP monitors. This kit normally is installed last in a rack
configuration. For convenience and safety install other
components and keyboard kit before installing this
Monitor Rack Mount Kit. This kit requires 11 EIA units
in your HP rack.
Contents
2 Rear Brackets
2 Sheet Metal Nuts
1 Monitor Base
2 Decorative Gray Screws
2 Torx 25 Screws with Lock
1 Front Bezel
3 Clamp Assemblies
Tools Needed: Torx 25 Driver
NOTE: Extend the rack's four stabilizer feet
before installing components in the rack.
67(3
Choose EIA location for the Monitor Base.
Determine where you want the bottom of the
Monitor Base. To place the monitor at the top of a
1.96m E-Series rack, use EIA 30. To place the
monitor at the top of a 1.6m E-Series rack, use
EIA 22.
67(3
Position and attach Rear Brackets.
Position the bottom of the Rear Brackets on the
rear columns at the desired EIA location. Install
with two non-decorative Torx 25 bolts.
EIA location for
Monitor Base bottom
26
67(3
Install Sheet Metal Nuts in front columns.
In the middle hole of the EIA unit located in Step
1, place sheet metal nuts on the front columns as
shown. The location is an example.
EIA location of Monitor
Base bottom
67(3
Install the Monitor Base.
Standing in front of the rack and holding the front
of the Monitor Base, move it to the rear. The pins
pointing in on the Rear Brackets fit into the
channels cut into the back of the Monitor Base.
Align the front of the Monitor Base at the EIA
location.
3
3
3
2
2
2
2
2
3
1
3
0
2
9
8
7
6
Procedures
3 1
3 0
2 9
Advertisement
Table of Contents
