Table of Contents
Advertisement
Chapter 4
Installing Universal Shelf
This kit requires 1 EIA unit in your HP rack.
Contents
2 Rear Brackets
2 Sheet Metal Nuts
1 Plain Shelf
2 Decorative Gray Screws
2 Torx 25 Screws with Lock Washers
Tools Needed: Torx 25 Driver
NOTE: Extend the rack's four stabilizer feet
before installing components in the rack.
Remove side panels to install the Plain Shelf.
67(3
Choose EIA location for the Plain Shelf.
Determine the height for the Plain Shelf and
locate EIA number on columns where bottom of
Plain Shelf is to be installed.
67(3
Position and attach Rear Brackets.
Position the bottoms of the Rear Brackets at the
desired EIA location. Install with two non
decorative Torx 25 bolts.
EIA location of
Shelf bottom
67(3
Install Sheet Metal Nuts in front columns.
In the middle hole of the EIA unit located in Step
1, place sheet metal nuts on the front columns as
shown. (The placement location shown is only an
example.)
EIA location of
Shelf bottom
67(3
Install Plain Shelf.
Standing in front of the rack and holding the front
of the Plain Shelf, move it to the rear. The pins
pointing in on the Rear Brackets fit into the
channels cut into the back of the Plain Shelf.
Align the front of the shelf at the EIA location.
3
3
3
2
2
2
2
3
1
3
0
2
9
8
7
Side view
67(3
Install Decorative Gray Screws in front
column.
Front holes in the Plain Shelf should align with
Sheet Metal Nuts attached in Step 3. Installation
complete.
Procedures
3 1
3 0
23
Advertisement
Table of Contents
