Dfrom; Digipeat; Disconne - Advanced Electronic Applications PK-88 Operating Manual

PK-88 OPERATING MANUAL
To permit one or more specific stations to digipeat through your station, type
lowed by a list of calls signs). Packets will be digipeated only from and to stations whose call signs
are listed.
To prevent one or more specific stations from digipeating through your station, type
followed by a list of call signs). Packets will not be digipeated only from and to stations whose call
signs are listed.
You can include optional SSIDs or extensions specified as
If DFROM is set to 'no WX1AAA' or 'yes WX1AAA', combinations WX1AAA WX1AAA-1 ..... WX1AAA-
15 will be matched and processed.
If DFROM is set to 'yes WX1AAA-1' or 'no WX1AAA-1,' then only WX1AAA-1 will match and be
processed.
Clear DFROM with %, &, or
DIGIPEAT ON|OFF
Parameters: ON
OFF
In host computer applications that use a Boolean parameter switching routine rather than numeric
values, the DIGIPEAT command can be used with ON and OFF instead of ALL or NONE.
This alternate DIGIPEAT command is appropriate in certain electronic mail and bulletin board sys-
tems.
Note that DIGIPEAT ON and OFF as Boolean commands do not provide the same capability for se-
lective digipeating as with DFROM YES(calls) and DFROM NO(calls).

DISCONNE

DISCONNE is an immediate command that initiates a disconnect request to the station to which
you are connected. If your disconnect command is successful, your monitor will display:
DISCONNECTED: {call sign}
Other commands can be entered while a disconnect is in progress. New connections are not al-
lowed until the disconnect is completed.
If the retry count is exceeded while waiting for the distant station to acknowledge your discon-
nect command, your PK-88 switches to the disconnected state.
If another disconnect command is entered while your PK-88 is trying to disconnect, the retry
count is immediately set to the maximum number. In either case, your monitor displays:
*** Retry count exceeded
*** DISCONNECTED: {call sign}
Disconnect messages are not displayed when the PK-88 is in the Transparent Mode.
OFF as arguments.
Mnemonic: DIG
Equivalent to DFROM ALL
Equivalent to DFROM NONE
Mnemonic: D
-n
after the call sign.
Default: ON
Immediate Command
5 - 31
COMMAND SUMMARY
DFROM (YES fol-
DFROM (NO
PK-88 - 106