Radio Connections And Setup - Advanced Electronic Applications PK-88 Operating Manual

PK-88 OPERATING MANUAL
13. Type C AAA
play:
14. Type a few characters, any characters, followed by a [↵]. After a few moments,
your monitor should echo the same characters that you have just typed.
15. Type [^C]
should respond with:
16. Type HB 300
17. Type [K]
just typed.
18. Type [^C]. Your monitor should respond with:
19. Type [D]
20. If you have done all these steps successfully, you have completed the system instal-
lation and you are ready to begin operating.
21. If you have problems with the steps shown above, return to Step 1 AFTER checking
all cables and connectors. Read each step again carefully. If you still have problems,
shut down the PK-88 and contact our Customer Service Department as suggested in
the front of this manual.
If all the front-panel LEDs remain lit at system start, verify that your power supply
can provide at least 600 ma. at 12 VDC.
2.8

Radio Connections and Setup

DISCONNECT ALL POWER BEFORE MAKING ANY OTHER CONNECTIONS!
Use this simple step-by-step routine to verify that all cables and connectors are properly in-
stalled, and that the PK-88 Packet Controller is operating correctly. The procedure will also
help you become familiar with the software commands and responses.
If you cannot solve a problem after carefully reading this manual and checking all cables
and connectors, please refer to the instructions for calling the manufacturer in the beginning
of the manual.
followed by a [RETURN]. After a few moments, your monitor should dis-
c aaa
cmd:
*** CONNECTED to AAA
) (type [C] while pressing the
cmd:
followed by a [RETURN]. Your monitor should respond with:
HBAUD was 1200
HBAUD now 300
followed by a [RETURN]. Your monitor should echo the characters you've
cmd:
followed by a [↵]. Your monitor should respond with:
d
cmd:
*** DISCONNECTED: AAA
[CONTROL]
2 - 6
INSTALLATION
key down). Your monitor
PK-88 - 22