Advertisement
INSTALLATION
„ Installation to the handlebars
1.
Mark the position for installing the switch.
2.
Attach rubber sheets A and B. At this time, make sure that A and B are attached in
the correct positions at left and right.
3.
Pass a cable tie through the large square hole in the switch.
4.
Secure the switch to the handlebars with the cable tie, and use pliers to cut off any excess length of cable tie.
5.
Turn the cable tie so that the square part goes into the square hole in the switch.
Do not secure the cable with the cable
tie as well at this time.
6
A
B
Advertisement
