Advertisement

Quick Links

Nice
CO Alarm-Control
CO and temperature sensor
EN - Instructions and warnings for installation and use

Advertisement

Table of Contents
loading

Summary of Contents for Nice CO Alarm-Control

  • Page 1 Nice CO Alarm-Control CO and temperature sensor EN - Instructions and warnings for installation and use...
  • Page 2: Warnings And General Precautions

    PRODUCT DESCRIPTION CO Alarm-Control is an ultra-light, compact, battery-powered carbon monoxide detector, designed to be placed on a wall. Its high sensitivity allows to detect the presence of the carbon monoxide (CO) gas at the early stage in order to prevent carbon monoxide poisoning.
  • Page 3: Adding The Device

    Recommended height of installation is dependant on the purpose of the room and height at which head typically is. • CO Alarm-Control may operate as a stand-alone carbon monoxide detector or may be used in cooperation with Z-Wave Controller (eg. Yubii Home) as a part of smart home system.
  • Page 4: Removing The Device

    REMOVING THE DEVICE Removing (Exclusion) - Z-Wave device learning mode, allowing to remove the device from existing Z-Wave network. To remove the device from the Z-Wave network: 1. Place the device within direct range of the Z-Wave controller. 2. Set the main Z-Wave controller in remove mode (see the controller’s manual). 3.
  • Page 5: Operating The Device

    Yellow - the device reset 5. Press the button to confirm selection. Note. CO Alarm-Control must be detached from the wall and battery level must be greater than 30% of its full capacity to perform the firm- ware update process.
  • Page 6 Using batteries other than specified may result in explosion. Dispose of properly, observing environmental protection rules. Use only type of battery specified in this manual and keep proper polarity! CO Alarm-Control can be powered with CR123A (included) battery. Estimated battery life with device on default settings is 3 years (tested with Panasonic Industrial Lithium).
  • Page 7: Advanced Parameters

    Wake up interval CO Alarm-Control will wake up at each defined time interval and always try to connect with the main controller. After successful communica- tion attempt, the device will update configuration parameters, associations, settings and then will go into Z-Wave communication standby.
  • Page 8 Parameter: 3. LED diode indications Description: This parameter allows to set the actions which result in LED diode indications. This parameter does not apply to the most important actions, such as CO Alarm, Malfunction Alarm and Low Battery Alarm. Parameter 3 values may be combined, e.g. 1+2+4=7 means that all actions will be active. Available settings: 0 - all actions disabled 1 - tampering (opened casing)
  • Page 9 Parameter: 13. Commands sent to 4th association group (CO Level) Description: This parameter defines commands sent to devices associated in 4th association group (CO Level). Values of specified commands may be set in parameters 16 and 19. Available settings: 1 - BASIC ON 2 - BASIC OFF 3 - BASIC ON &...
  • Page 10 Parameter: 23. CO meter activation Description: This parameter activates reporting the value of CO concentration level to the main Z-Wave controller. Available settings: 0 - disabled 1 - enabled Default setting: 1 (enabled) Parameter size: 1 [byte] Parameter: 25. CO level reporting hysteresis Description: This parameter defines a minimum change in CO concentration level which results in sending a new value to the main Z-Wave controller.
  • Page 11: Technical Specifications

    The product CO Alarm-Control is produced by Nice S.p.A. (TV). Warnings: - All technical specifications stated in this section refer to an ambient temperature of 20 °C (± 5 °C) - Nice S.p.A. reserves the right to apply modifications to the product at any time when deemed necessary, while maintaining the same functionalities and intended use.
  • Page 12: Product Disposal

    Caution! – local legislation may envisage serious fines in the event of abusive disposal of this product. DECLARATION OF CONFORMITY Hereby, Nice S.p.A., declares that the radio equipment type CO Alarm-Control is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.niceforyou.com/en/support...
  • Page 13 Nice SpA Oderzo TV Italia www.niceforyou.com info@niceforyou.com...

Table of Contents