Table of Contents
Advertisement
5
REMOVING THE DEVICE
Removing (Exclusion) - Z-Wave device learning mode, allowing to remove the device from existing Z-Wave network.
To remove the device from the Z-Wave network:
1. Place the device within direct range of the Z-Wave controller.
2. Set the main Z-Wave controller in remove mode (see the controller's manual).
3. Quickly, triple click the button located on the casing.
4. Wait for the removing process to end.
5. Successful removing will be confirmed by the Z-Wave controller's message.
Note. Removing the device from the Z-Wave network restores all the default parameters of the device.
6
PHYSICAL INSTALLATION
Read before installation and heed all the warnings!
•
The device should be installed below the ceiling level.
•
The device should be installed on the wall, at least 30 cm (1 ft) away from the corners.
•
The device should not be installed: in a bathroom, next to heat sources, within range of kids, obstructed from possible carbon monoxide
sources, in direct sunlight.
•
The device should be installed by a qualified installer.
•
Do not paint the device.
•
The device should be cleaned with a slightly damp cloth or moistened tissue.
•
Remember to add the device to the Z-Wave network prior to installation, as the adding procedure must be performed within the direct
range of the controller.
6.1 - Place of installation
•
Recommended height of installation is dependant on the purpose of the room and height at which head typically is.
6.2 - Installation on the wall
1. Mount the cover on a wall.
2. Attach the device to its cover.
3. Turn the device clockwise to close it.
CEILING
30cm/1ft
NOT HERE
WALL
HERE
1.5m/5ft
FLOOR
1.
2.
3.
Advertisement
Table of Contents
