Operating The Device - Nice CO Alarm-Control Instructions And Warnings For Installation And Use

7

OPERATING THE DEVICE

7.1 - Menu
Menu allows to perform Z-Wave network actions. In order to use the menu:
1. Press and hold the button for 3 seconds.
2. You should hear a short signal while the LED diode blinks white.
3. Release the button.
4. Wait for the device to indicate desired menu position with a colour:
White - confirm the start of the firmware update process
Green - send the current state of CO Alarm
Magenta - Z-Wave network's range test
Yellow - the device reset
5. Press the button to confirm selection.
Note. CO Alarm-Control must be detached from the wall and battery level must be greater than 30% of its full capacity to perform the firm-
ware update process.
7.2 - Waking up the device
CO Alarm-Control needs to be woken up to receive information about the new configuration from the Z-Wave controller, like parameters and
associations. To wake up the sensor manually click the button located on the casing.
7.3 - Self-test
If the self-test procedure does not result in emitting sound and red light signal, replace the device.
1. Press and hold the button.
2. The LED indicator will glow white and you will hear a short beep.
3. Release the button when you hear the first alarm sequence.
4. Move away from the device to protect your hearing.
Note. The alarm is very loud! Only the first alarm sequence is quieter.
7.4 - Resetting the device to factory defaults
Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user
configuration will be deleted.
1. Press and hold the button.
2. Release the button when LED indicator glows white and short beep sounds.
3. Click the button when LED indicator glows yellow.
4. After few seconds the device will be reset (confirmed by red LED indicator and long beep).
Note. Resetting the device is not the recommended way of removing the device from the Z-Wave network. Use the reset procedure only if
the primary controller is missing or inoperable. Certain device removal can be achieved by the procedure of removing described in section
"Removing the device".