Nice CO Alarm-Control Instructions And Warnings For Installation And Use page 6

8
VISUAL INDICATIONS & ACOUSTIC SIGNALS
CO Alarm-Control is equipped with a LED diode and a buzzer, signalling menu position and status of the device.
Table A1 - Device status indications
4 x BEEP 4 x RED BLINK every
every 5s 5s
1 x YELLOW BLINK
1 x BEEP
every 30s
1 x BEEP
–
every 30s
2 x CYAN BLINK every
2 x BEEP
30s
3 x BEEP 1 x BLUE BLINK every
every 30s 30s
1 x BEEP 1 x WHITE BLINK
1 x GREEN BLINK after
–
button press
1 x GREEN BLINK after
1 x BEEP
powering
1 x RED BLINK
1 x BEEP
after powering
1 x MAGENTA BLINK
1 x BEEP
every 10min
– CYAN BLINKING
9
OPERATING THE DEVICE
Using batteries other than specified may result in explosion. Dispose of properly, observing environmental protection rules.
Use only type of battery specified in this manual and keep proper polarity!
CO Alarm-Control can be powered with CR123A (included) battery. Estimated battery life with device on default settings is 3 years (tested with
Panasonic Industrial Lithium).
9.1 - Checking battery level
CO Alarm-Control automatically warns about low battery with one yellow blink and a short beep, when battery level is low.
9.2 - Replacing the battery
In order to replace the battery:
1. Remove the device from the cover by turning it counter-clockwise.
2. Pull the paper strip to take out the battery.
3. Press and hold the button for at least one second.
4. Insert a new CR123A battery observing the polarities shown inside.
5. Attach the device to its cover by turning it clockwise and perform the battery test described above.
10
ASSOCIATIONS
Association (linking devices) - direct control of other devices within the Z-Wave system network e.g. Dimmer, Relay Switch, Roller Shutter
or scene (may be controlled only through a Z-Wave controller).
Association allows direct transfer of control commands between devices, is performed without participation of the main controller and re-
quires associated device to be in direct range.
Detected presence
of carbon monoxide
which can kill you!
Low battery level
Sensor error (does not
detect carbon mon-
oxide)
End of lifespan
Heat alarm
Tamper alarm
Device powered
Added to Z-Wave
Not added to Z-Wave
Out of range
Firmware update
1. Open the windows
2. Move to fresh air!
3. Contact emergency
services
Replace the battery
Reset the device,
replace if no effect
Reset the device,
replace if no effect
Be cautious of fire
Check the housing
–
–
–
Check the Z-Wave range
Wait for completion