Messages - Casio KL-C500 User Manual

Using Labels
Label will not adhere to a surface.
Possible Cause
The backing paper is still Peel the backing paper from the back of the
on the back of the tape. tape to expose the adhesive.
Surface is unsuitable for Labels do not adhere well to surfaces that are
affixing a tape. rough, wet, oily, or dirty.
Data Communication
Cannot transfer data.
Possible Cause
Poor data communication Make sure the data communication cable jacks
cable connection are connected securely.
Passage of too much time Be sure to start actual data transfer within about
after setting up for data 20 seconds after pressing SET to start a data
communication communication operation.

Messages

The messages in the following table are listed in alphabetical order.
Message Possible Cause
CANCEL You changed the
FORMAT? number of lines.
SET/ESC You specified char-
acter size (points) for
individual characters.
CANNOT Recalling text into ex-
INSERT! isting text results in
more than 511 charac-
ters or 16 blocks.
Action
Action
Action Page
To cancel preset for- E-23
mat specification
press SET.
If you do not want to
cancel the specifica-
tion, press ESC.
Reduce the number of E-15
characters or blocks in E-25
existing text.
Message Possible Cause
CANNOT Even number of dig-
PRINT! its input for ITF bar
BAR CODE code when a check
MUST HAVE digit is being used.
EVEN NUMBER Odd number of digits
OF DIGITS! input for ITF bar code
when a check digit is
not being used.
CANNOT PRINT! Bar code printed does
NOT ENOUGH not have enough digits.
DIGITS!
CANNOT Invalid characters
PRINT! used in a bar code.
YOU ARE Letter other than A,
USING ILLEGAL B, C or D input for
CHARACTERS! CODABAR bar code
start code or end
code.
CANNOT Attempt made to recall
RECALL barcode data as text.
MEMORY DATA
IN THIS MODE!
DATA ERROR! Corrupted or lost
RESET THE memory contents
LABEL due to low battery
PRINTER! power.
Attempting to save
text in memory be-
fore initializing
memory.
Attempting to print
text before initializing
memory.
GETTING Printer is hot.
READY...
Action Page
Add a 0 (zero) at the E-43
first digit and re-input.
Add a 0 (zero) at the
first digit and re-input.
Re-input with the E-43
proper number of dig-
its.
Change to allowed E-43
characters.
Use only the allow-
able characters.
Recall data as barcode E-36
data in the PRESETS
menu.
Perform the reset op- E-8
eration and try again.
Wait for a while. Print-
E-29
ing will resume when
temperature returns to
normal.
If this problem hap-
pens often, try mak-
ing the print density
lighter (lower).
E-45