Direct Specification Of Character Sizes - Casio KL-C500 User Manual

Direct specification of character sizes

You can specify the character size in points to any one of 14 sizes from 9pt to
119pt.
A character size change is indicated on the display by a character size mark.The
following table shows the 14 character sizes that are available.
Character size (point)
9pt
12pt
14pt
17pt
20pt
26pt
34pt 12mm
43pt 15mm
51pt 18mm
59pt 21mm
68pt 24mm
E-22
Actual Size (mm)
3mm
4mm
5mm
6mm
7mm
9mm
Character size (point)
85pt 30mm
102pt 36mm
119pt 42mm
Important! Note that the millimeter sizes shown in the above table are ap-
proximations only. The actual size may be smaller, depending on the font you
are using.
The vertical character sizes you can use are automatically limited by the tape
width of the tape loaded in the label printer.
Actual Size (mm)