Deda Elementi Vinci Use And Maintenance Manual page 19

UPPER BEARING POSITION:
Upper bearing position has to observe
following dimensions:
8,8
In case of assembling on DCR frameset, cables
will enter close to the levers and will go out under
the stem, passing across the spacers, top cover
of 56 mm (14) and compression ring 36°×45° (16)
or 45°×45°( included with DEDA DCR headset).
Here below a picture showing the full internal
cables routing.
Vinci Handlebar and Stem
Ø 56,0
Ø 28,7
"D-SHAPE" FORK FRAMESET
This frameset has got an upper bearing of 1" 1/8
and a "D-shape" fork of 1" 1/8. In this case the
headset top cover of 46 mm (16) could be used.
In case of assembling on "D-shape" fork, cables
will enter close to the levers and will go out under
the stem, passing across the spacers and top
cover of 46 mm (16). For the stem assembly on
Ridley or Dedacciai frame, an adapter for the
headset top cap has to be used (available
as spare part cod. HDVCNTPA) coupled to a
standard top cap.
8,7
D-SHAPE TOP
CAP ADAPTER TOP CAP
19