Cables Routing - Deda Elementi Vinci Use And Maintenance Manual

4. Cables routing

Vinci, handlebar and stem, are compatible both for external
and full internal cable routing.
TRADITIONAL FRAMESET
(EXTERNAL CABLE ROUTING)
In case of assembling on traditional frameset,
cables will enter close to the levers and will
go out from the exit holes under the handlebar.
Here below a picture showing the cables
passages. In this case the headset top cover
of 46 mm could be used (16).
REMARK: The bikes with external cable routing
and 1"1/4 are compatible with Vinci. In this case
assembly the stem without the alloy sleeve (8)
and topcover 52 mm (available as accessory
under the code HDVCNT52).
Passaggio
cavi esterno
DCR FRAMESET
(INTERNAL CABLE ROUTING)
DCR (DEDA internal cable routing) frameset
uses a fork with forktube 1" 1/8 and headset upper
bearing of 1,5".In this case the headset top cover
of 56 mm (14) and compression ring of 36°×45°
(17) or 45°×45° (*) could be used. In order
to use the complete internal cables routing,
the frame and the fork have to be compatible.
Here below the features to be met.
* Included with DEDA DCR headset.
FORK: The fork should have an hole for the
entrance of the brake front cable in the fork
steerer in order to allow the cable routing
up to the exit on the braking area.
Front disc brake
cable routing
dedaelementi.com