Toshiba B-FP3D-GH52-QM-R Owner's Manual page 5

Keep away from microwave devices.
Communication performance may deteriorate or a communication error may occur due to radio interference emitted from the
microwave device.
Since the Bluetooth and wireless LAN use the same radio frequency band, each radio wave may interfere with each other when
they are used at the same time, causing a deterioration of communication performance or a disconnection of network. If there is
any problem with connection, please stop using either Bluetooth or wireless LAN.
Do not use the product on a metal table or near a metal object.
Communication performance may be deteriorated.
BT800 Specification
Bluetooth version V4.0 Dual Mode
Frequency 2.402 to 2.480 GHz
Maximum Transmit Class 1
Power +8 dBm from antenna "
Receive Sensitivity -89 dBm
Data Rates Up to 3 Mbps (over the air)
Communication distance 3m/360deg (For FP3D specification)
US/FCC: SQGBT800, CANADA/IC:
Certification (Module)
3147A-BT800
(Put on "Contains FCC ID: SQG-
BT800" in certification label)
Europe: RE 2014/53/EU
PN: AT3216-B2R7HAA, Mfg.: ACX,
Antenna specification
Type Ceramic, Gain: 0.5(dBi)
CAUTION!
1. To avoid injury, be careful not to catch or jam your fingers while opening or closing the cover.
2. Do not touch moving parts. To reduce the risk that fingers, jewelry, clothing, etc., be drawn into the moving parts, turn off the
power switch to stop movement.
Safety Summary
Personal safety in handling or maintaining the equipment is extremely important. Warnings and Cautions necessary for safe
handling are included in this manual. All warnings and cautions contained in this manual and written inside or outside of the printer
should be read and understood before handling or maintaining the equipment.
Do not attempt to effect repairs to this equipment. If a fault occurs that cannot be rectified using the procedures described in this
manual, turn off the power, then contact your authorised TOSHIBA TEC representative for assistance.
Safety Precautions
This Owner's Manual and the products (machines) which you have purchased contain indications which should be observed in
order to use the machines safely and prevent harm to yourself and others and damage to property. The meanings of these
indications and symbols are given below.
Read these indications and become familiar with their contents before reading this Owner's Manual.
Precautions
The following precautions will help to ensure that this machine will continue to function correctly.
(1) Try to avoid locations that have the following adverse conditions:
*Temperatures out of the specification
*High Humidity
*Direct sunlight
*Excessive vibration
(2) The cover should be cleaned by wiping with a dry cloth or a cloth slightly dampened with a mild detergent solution. NEVER
USE THINNER OR ANY OTHER VOLATILE SOLVENT on the plastic covers.
(3) USE ONLY TOSHIBA TEC SPECIFIED media.
(4) DO NOT STORE the media where it might be exposed to direct sunlight, high temperatures, high humidity, dust, or gas.
(5) Any data stored in the memory of the printer could be lost during a printer fault.
(6) DO NOT open the top cover and battery cover during operation. Doing so will stop printer operation.
(7) DO NOT scratch the surface of printed labels or receipt with a sharp object.
(8) Be sure to use a shielded interface cable.
CAUTION!
1. This manual may not be copied in whole or in part without the prior written permission of TOSHIBA TEC.
2. The contents of this manual may be changed without notification.
3. Please refer to your local Authorised Service representative with regard to any queries you may have in this manual.
RS9113 Specification
Standard IEEE802.11 a / b / g / n
"2412 MHz – 2484 MHz/4910 MHz – 5825 MHz"
Frequency
Spacing 5 MHz(2.4GHz),20 MHz(5GHz)
Channel: US : 1 - 11, 36 - 48, 52 - 64, 100 - 116,
120 - 128, 132 - 140, 149 - 165
Europe : 1- 13, 36 - 48, 52 - 64, 100 - 140
Antenna PCB Trace antenna (built-in module) @2.0dBi
Communication speed/
Modulation 802.11b: 1, 2, 5.5, 11 Mbps
802.11g: 6, 9, 12, 18, 24, 36, 48, 54 Mbps
802.11n: MCS0 to MCS7 with and without Short GI"
OFDM with BPSK, QPSK, 16-QAM, and 64-QAM
802.11b with CCK and DSSS"
Receive Sensitivity -97 dBm
Transmission output 18 dBm
5