Toshiba B-FP3D-GH52-QM-R Owner's Manual page 19

Error Message
FLASH MEMORY FULL
LOW BATTERY
EXCESS HEAD
TEMPERATURE
AMBIENT TEMP
ERROR
BATTERY TEMP
ERROR
HIGH VOLT. ERROR
CHARGE ERROR
Command error
example
PC001;0A00,0300,
Other error messages
****: The number of unprinted labels 1 to 9999 (in units of label)
Cause
The flash memory has insufficient area
for storing data.
Remaining battery capacity is low.
The print head temperature reached the
upper limit of the operating temperature.
The ambient temperature reached the
upper limit of the operating temperature.
The battery is extremely hot.
The battery voltage is abnormal.
An error was detected while charging
the battery.
When a command error occurs, up to 16
digits of alphanumeric or symbol is
displayed on the upper line of the LCD.
A hardware or software failure occurs.
Turn off the [POWER] button, then back
to on. Re-format the memory to free up
space then send data from the host to
the printer again. If the problem recurs,
please turn off the power and contact
TOSHIBA TEC service representative.
Turn off the printer, and replace the
battery pack with a fully charged one.
Stop printing and wait until the printer
automatically restores. If the problem
recurs, please turn off the power and
contact TOSHIBA TEC service
representative.
Stop printing until the ambient
temperature falls within the printer's
operating temperature range.
Turn off the printer, disconnect the
power adapter if connected, and wait
until the battery temperature falls within
the printer's operating temperature
range.
Turn off the printer, remove the battery,
reload it, and turn on the printer again
If the problem recurs, please turn off the
power and contact TOSHIBA TEC
service representative.
It could be the end of battery life.
Replace the battery pack with a new
one.
Turn off the printer, then back on. Send
data from the host to the printer again.
If the problem recurs, please turn off the
power and contact TOSHIBA TEC
service representative.
Turn off the printer, then back on. If the
problem recurs, please turn off the
power and contact TOSHIBA TEC
service representative.
20
Solution