Table of Contents
Advertisement
20. When slightly adjustment is needed, use "ORIG. POINT" mode.
21. To enter to "G-ORIG. POINT" (for green) mode press TV/VIDEO.
22. With "ORIG. POINT", the adjustment data changes by 1 step, this
allows more detail in the adjustment. Display values on screen by
pressing RECALL on remote
23. Confirm that green adjustment is good enough, if adjustment is not
satisfactory, repeat adjustments.
24. Enter to LINE "G-LINE" mode by pressing TV/VIDEO.
25. LINE mode allows to move each single line horizontally and vertically
(see figure)
26. Begin adjustment from the center to the edge of the screen (see
figure)
27. Adjust to make distribute lines
LINE, POINT, ORIG. POINT modes, possible locations for cursor
28. Then press "1 or 3" on the remote until red and green appears.
NOTE:
Since convergence adjustment will not allows to adjust every single cross section of the grid, it is
very important to adjust, so that overall looks best, in "FINE" mode press "4" frequently on remote
controlto cycle crosshatch pattern to verify convergence.
"LINE" mode adjustment
68
Advertisement
Table of Contents
