right - left and CH up - down.
PROCEDURE:
1. To Enter to "G-EASY" mode (for green):
- Select "EASY" DAC
- Press POWER on remote
- Press TV/VIDEO (repeatedly) to select mode.
- Press R-TUNE (repeatedly) to select color
2. Press "2" repeatedly and apply the pattern of crosshatch.
3. Press "4" frequently to change crossed sections, this helps to check
convergence more accurate in more sections of the picture.
4. Press "1 or 3" repeatedly until the pattern becomes green.
5. Press RECALL to display values.
6. In "EASY" mode, the adjustment value changes by 4 steps
7. "EASY" mode allows to move lines horizontally and vertically from the
center of cursor
8. This mode affects a wide area around the cursor than other
adjustment modes, See values on screen by pressing RECALL on
remote
9. Begin adjustment from the center to the edge of the screen.
10. Adjust when the cursor is not flashing by pressing CH up/down and
VOL right/left on the remote control, if the cursor is flashing press
MUTE on the remote
"EASY" mode adjustment, possible locations for cursor
"EASY" mode adjustment
66