Table of Contents
Advertisement
- EXT to copy from jig to internal EEPROM.
5. Then select from and press ACTION on remote:
- 480i_p format
- 1080i format
- Z480i format (480i ZOOM mode)
- NOT USE to back up data
- ALL to copy all convergence data from internal EEPROM
- D480i (default factory preset)
- D1080i (default factory preset)
NOTE:
The stated as default factory preset contain the factory DATA; Use these when data was lost or
is hard to adjust.
6. Select from and then press ACTION on remote:
- INT to copy data to internal EEPROM
- EXT to copy data to jig.
7. Then select which data format you want to copy to.
8. When completed, exit the service mode.
12. A-Board check points
A-Board check points
19
Advertisement
Table of Contents
