CAUTION
- Pb free solder has a higher melting point than standard solder.
Typically the melting point is 50 ~ 70 °F (30 ~ 40 °C) higher. Please use
a high temperature soldering iron and set it to 700 ± 20 °F (370 ± 10 °C).
- Pb free solder will tend to splash when heated too high (about 1100 °F
or 600 °C). / If you must use Pb solder, please completely remove all of
the Pb free solder on the pins or solder area before applying Pb solder.
If thisis not practical, be sure to heat the Pb free solder until it melts,
before applying Pb solder.
- After applying PbF solder to double layered boards, please check the
component side for excess solder which may flow onto the opposite
side.
Suggested Pb free solder
There are several kinds of Pb free solder available for purchase. This product uses Sn+Ag+Cu (tin,
silver, copper) solder. However, Sn+Cu (tin, copper), Sn+Zn+Bi (tin, zinc, bismuth) solder can also
beused.
4