Useful Features; Locking The Operation Buttons On The Projector; Deselecting Inputs - Sharp XG-V10XU Operation Manual

Useful Features

Locking the Operation Buttons on the Projector

Projector
(GUI) On-screen Display

Deselecting Inputs

Projector
(GUI) On-screen Display
E-59
Remote Control
1, 6
2, 3, 4
5
1.2.3 4.5.6
Remote Control
1, 6
2, 3, 4
5
1.2.3 4.5.6
This function can be used to lock the use of certain
operation buttons on the projector. The user can still
operate the projector fully with the remote control.
Description of Keylock Levels
Selected item
Description
Normal All operation buttons are functional.
Level A
Only INPUT, VOLUME, MUTE, on the
projector are available.
Level B
All operation buttons on the projector are
unavailable.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Options (2)".
3 Press ∂/ƒ to select
press ©.
4 Press ∂/ƒ to select the desired level.
5 Press ENTER to save the setting.
6 To exit from the GUI, press MENU.
• To cancel the Keylock Level, perform the above procedure using
the remote control.
• See page 61 for details using the password function.
This function allows you to deselect unwanted signal
input.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Options (2)".
3 Press ∂/ƒ to select
press ©.
4 Press ∂/ƒ to select the input you want to set to
block.
5 Press ENTER to select "ON" or "OFF".
6 To exit from the GUI, press MENU.
• Input 6 can be selected only when an SDI board is installed.
Otherwise it is displayed in gray.
• When stack projecting, multi-screen projecting and so on, this
function can be used to cancel the RS-232C control.
• Up to two input signals can be blocked for both Input 1, 2, 3 or
Input 4, 5, 6.
• For details on intended purpose, see pages 67 and 68.
MOUSE ADJ.
"Keylock Level", and then
MOUSE ADJ.
"Set Inputs", and then