Caution Concerning The Lamp Replacement; Caution Concerning The Lamp Unit; Cautions Concerning The Setup Of The Projector; Notes On Operation - Sharp XG-V10XU Operation Manual

IMPORTANT SAFEGUARDS
"COMPLIES WITH 21 CFR SUBCHAPTER J"
CAUTION
SHARP ELECTRONICS CORPORATION
SHARP PLAZA, MAHWAH, NEW JERSEY 07430
TEL : 1-800-BE-SHARP
LASER RADIATION-
DO NOT STARE INTO BEAM
REMOTE CONTROL
MODEL NO. : RRMCG1564CESA
WAVE LENGTH : 650nm
DC3V (1.5VX2PCS.)
MAX. OUTPUT : 1mW
MADE IN CHINA
CLASS II LASER PRODUCT FABRIQUÉ AU CHINE
AVOID EXPOSURE
-
LASER
RADIATION IS EMITTED
FROM THIS APERTURE.
LAMP REPLACEMENT CAUTION
BEFORE REMOVING THE SCREW, DISCONNECT
POWER CORD. HOT SURFACE INSIDE ALLOW
1 HOUR TO COOL BEFORE REPLACING THE
LAMP. SEE OPERATION MAN UAL.
CAUTION
POTENTIAL HAZARD OF GLASS
PARTICLES. SEE OPERATION MANUAL.
ATTENTION
LAMPE. DANGER POTENTIEL DE PARTICULES DE
VERRE. SE REPORTER AU MODE D'EMPLOI.
104˚F
( 40˚C)
41˚F
( 5˚C)
E-3
Cautions Concerning the Laser Pointer
U.S.A. ONLY
The laser pointer on the remote control emits a laser beam from the laser
pointer window. This is a Class II laser which may impair your sight if directed
into the eyes. The three marks shown on the left are caution labels for the
laser beam.
• Do not look into the laser pointer window or shine the laser beam on yourself or
others. (The laser beam used in this product is harmless when directed onto
the skin. However, be careful not to project the beam directly into the eyes.)
• Always use the laser pointer at temperatures between 41°F and 104°F ( 5°C
and
• Use of controls or adjustments, or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
Laser pointer
window

Caution Concerning the Lamp Replacement

See "Replacing the Lamp" on pages 71 and 72.

Caution Concerning the Lamp Unit

Potential hazard of glass particles if lamp ruptures. In case of lamp rupture,
contact your nearest Authorized Sharp Industrial LCD Products Dealer or
Service Center for a replacement.
See "Replacing the Lamp" on pages 71 and 72.
LAMP MAY RUPTURE.
RUPTURE POSSIBLE DE LA

Cautions Concerning the Setup of the Projector

For minimal servicing and to maintain high image quality, SHARP recommends
that this projector be installed in an area free from humidity, dust and cigarette
smoke. When the projector is subjected to these environments, the lens must
be cleaned more often. As long as the projector is properly maintained in this
manner, use in these environments will not reduce the overall operation life.
Please note that all internal cleaning must be performed by an Authorized
Sharp Industrial LCD Products Dealer or Service Center.

Notes on Operation

• The exhaust vent, the lamp cage cover and adjacent areas may be extremely
hot during projector operation. To prevent injury, do not touch these areas until
they have sufficiently cooled.
• Allow at least 4 inches (10 cm) of space between the exhaust vent and the
nearest wall or obstruction.
• If the cooling fan becomes obstructed, a protection device will automatically
turn off the projector lamp. This does not indicate a malfunction. Remove the
projector power cord from the wall outlet and wait at least 10 minutes. Then
turn on the power by plugging the power cord back in. This will return the
projector to the normal operating condition.
40°C).