Auto Sync Adjustment; Auto Sync Display Function - Sharp XG-V10XU Operation Manual

Adjusting the Computer Images (RGB menu only)
Projector
(GUI) On-screen Display
On-screen Display
(GUI) On-screen Display
E-49
Remote Control
1, 5
2, 3, 4
1.2.3 4.5.6
AUTO SYNC
button
g
f
s
Auto Sync Adjustment
• Used to automatically adjust a computer image.
• Auto Sync adjustment can be made manually by
pressing AUTO SYNC, or automatically by setting
"Auto Sync" to "ON" in the projector's GUI menu.
When "Auto Sync" is set to "ON":
• The sync adjustment is automatically made each time
the projector is turned on while connected to a com-
puter or the input selection is changed.
• The Auto Sync adjustment setting previously made is
cleared when the projector's setting is changed.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Fine Sync".
3 Press ∂/ƒ to select "Auto Sync".
4 Press ß/© to select "ON".
5 To exit from the GUI, press MENU.
• Automatic adjustments can be made by pressing AUTO
SYNC.
• When the optimum image cannot be achieved with Auto
Sync adjustment, use manual adjustments. (See page 46.)
During Auto Sync adjustment, the On-screen Display
changes as shown on the left.
• Auto Sync adjustment may take some time to complete,
depending on the image of the computer connected to the
projector.

Auto Sync Display Function

Normally, an image is not superimposed during Auto
Sync adjustment. You can, however, choose to
superimpose a background image during Auto Sync
adjustment.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Fine Sync".
3 Press ∂/ƒ to select "Auto Sync Disp".
4 Press ß/© to select "
background image or "
background image during Auto Sync adjustment.
5 To exit from the GUI, press MENU.
MOUSE ADJ.
MOUSE ADJ.
" to superimpose a
" to remove the