Avaya CyberGear Alchemy Series Reference Manual page 19

S-R
EGISTERS
S-Reg. Description
S0 Auto-Answer.
S1 Ring counter (Read only).
S2 Escape character.
S3 Carriage Return character.
S4 Line Feed character.
S5 Back Space character.
S7 Dial timeout.
S10 DCD pulse length.
S12 Guard time.
ATA - A
NSWER CALL
The Auto Answer function of the CyberGear is controlled via the ATA and the ATS0
commands.
The ATS0 command sets the number of rings detected before the unit will answer the
incoming call. The value of ATS0 should be set to any value between 1 and 127. Setting
ATS0 to 0 disables the Auto Answer functionality.
The ATA command allows the incoming call to be answered manually.
ATB - S
N ET MODE
The ATBn command is used to set the way in which the data received and transmitted on
the ISDN link is structured.
ATB0 - sets the link protocol to Point to Point Protocol (PPP). This is used when the
remote end of the link only allows one connection per user.
ATB1 - sets the link protocol to be Multi Link Point to Point Protocol. This is used when
the remote end of the link allows multiple simultaneous connections from the
same source.
ATB2 - sets the link protocol to V.120 (Numbered datagrams). V.120 is a standard rate
adaptation mechanism used by TAs to convert asynchronous data, received from
the PC, to synchronous data on the ISDN connection.
ATB3 - sets the link protocol to V.110. V.110 is also a rate adaptation mechanism. Its
main use is for data connections over the GSM Network
ATB20 - sets the link protocol to V.120 (Un-numbered datagrams) This option should be
used if it is not possible to establish a V.120 connection using ATB2.
Possible Values
Range: 0 – 255
(0 = Disabled)
- - -
Range: 0 – 127
(0 = Disabled)
Range: 0 - 127
Range: 0 - 127
Range: 0 - 127
Range: 1 – 255 secs.
Measured in secs.
Range: 1 – 255
Measured in 1/10 sec.
Range: 0 – 255
Measured in 1/50 sec.
Table 3
5-3
The AT Command Set
Default Value
Default = 0.
- - -
Default = 43 (+).
Default = 13.
Default = 10.
Default = 8.
Default = 30.
(30 sec)
Default = 14
(1.4 sec).
Default = 50
(1.0 sec).
.