Table of Contents
Advertisement
THIS FIXTURE IS COMPOSED OF SOPHISTICATED ELECTRONIC COMPONENTS. TO GUARANTEE
SMOOTH OPERATION, IT IS IMPORTANT TO FOLLOW ALL INSTRUCTIONS AND GUIDELINES IN
THIS MANUAL. ADJ PRODUCTS, LLC IS NOT RESPONSIBLE FOR INJURY AND/OR DAMAGES
RESULTING FROM THE MISUSE OF THIS FIXTURE DUE TO THE DISREGARD OF THE INFORMATION
PRINTED IN THIS MANUAL. ONLY QUALIFIED AND/OR CERTIFIED PERSONNEL SHOULD PERFORM
INSTALLATION OF THIS FIXTURE AND ONLY THE ORIGINAL RIGGING PARTS INCLUDED WITH THIS
FIXTURE SHOULD BE USED FOR INSTALLATION. ANY MODIFICATIONS TO THE FIXTURE AND/OR
THE INCLUDED MOUNTING HARDWARE WILL VOID THE ORIGINAL MANUFACTURER'S WARRANTY
AND INCREASE THE RISK OF DAMAGE AND/OR PERSONAL INJURY. ONLY CERTIFIED PERSONNEL
SHOULD PERFORM INSTALLATION OF THIS FIXTURE.
•
PROTECTION CLASS 1 - FIXTURE MUST BE PROPERLY GROUNDED.
•
THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT.
•
DO NOT ATTEMPT ANY REPAIRS YOURSELF; DOING SO WILL VOID YOUR MANUFACTURER'S
WARRANTY. DAMAGES RESULTING FROM MODIFICATIONS TO THIS FIXTURE AND/OR THE
DISREGARD OF SAFETY INSTRUCTIONS AND GUIDELINES IN THIS MANUAL VOID THE
MANUFACTURER'S WARRANTY AND ARE NOT SUBJECT TO ANY WARRANTY CLAIMS AND/OR
REPAIRS.
•
DO NOT USE OUTDOORS OR EXPOSE TO MOISTURE OR HUMIDITY!
•
DO NOT PLUG UNIT INTO A DIMMER PACK!
•
NEVER OPEN THIS UNIT WHILE IN USE!
•
UNPLUG POWER BEFORE SERVICING UNIT!
•
NEVER TOUCH UNIT DURING OPERATION, AS IT MAY BE HOT!
•
KEEP FLAMMABLE MATERIALS AWAY FROM UNIT!
•
MINIMUM DISTANCE TO OBJECTS/SURFACES IS 6.6 FEET (2 METERS)
• OPERATING AMBIENT TEMPERATURE RANGE IS -4° F TO 158° F (-20°C TO 70°C). DO NOT
OPERATE THE DEVICE WHEN AMBIENT TEMPERATURE FALLS OUTSIDE THIS RANGE.
• MINIMUM DISTANCE TO FLAMMABLE MATERIALS FROM THE SURFACE IS 1.6 FEET (0.5 METER).
•
DO NOT TOUCH the unit housing during operation. Turn OFF the power and allow approximately 60 min-
utes for the unit to cool down before serving.
•
DO NOT shake unit, and avoid brute force when installing and/or operating unit.
•
DO NOT operate unit if the power cord is frayed, crimped, damaged and/or if any of the power cord con-
nectors are damaged and do not insert into the unit securely with ease. NEVER force a power cord con-
nector into the unit. If the power cord or any of its connectors are damaged, replace it immediately with a
new one of the same power rating.
•
DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never blocked. Allow
approx. 6" (15cm) between unit and other devices or a wall for proper cooling.
•
Always disconnect unit from main power source before performing any type of service and/or cleaning
procedure.
•
Only handle the power cord by the plug end. Never pull out the plug by tugging the wire portion of the
cord.
•
Consistent operational breaks will ensure fixture will function properly for many years.
•
ONLY Use original packaging and materials to transport the fixture in for service.
SAFETY GUIDELINES
7
Advertisement
Table of Contents
