Safety Policy - Seco Smarc LEVY User Manual

Table of Contents

1.7 Safety Policy

In order to meet the safety requirements of IEC 62368-1:2018 standard for Audio/Video, information and communication technology equipment, the LEVY Module

shall be:

used exclusively on SMARC 2.1 fully compliant Carrier boards;

connections from or to the Module have to be compliant to ES1 requirements;

used inside a fire enclosure made of non-combustible material or V-1 material (the fire enclosure is not necessary if the maximum power supplied to the

module never exceeds 100 W, even in worst-case fault);

used along with CPU Heatspreader/heatsinks designed according to the thermal characteristics indicated in the par. 2.2 and to the mechanical characteristics

indicated in par.2.4.

The manufacturer which includes a LEVY module in his end-user product shall:

Install the device inside an enclosure compliant with all applicable IEC 62368-1 requirements;

Prevent children from accessing the board;

Prescribe temperature and humidity range for operating, transport and storage conditions;

verify the compliance with B.2 and B.3 clauses of the IEC 62368-1 standard when the module works in its own final operating condition;

provide an instructional safeguard against thermal injuries, according to clause 9.5.2 of the above mentioned standard. This instructional safeguard must be

placed both on end-

When an heatsink with FAN is used, then the FAN should be managed with signals made available by SMARC Card Edge Connector of the LEVY module.

Its electrical characteristics must be compliant to the requirements of SMARC Rel.2.1 standard.

LEVY

IEC 60417-5041, it must be placed near the CPU or its heatsink);

Table of Contents