SECO S.p.A. reserves the right to change precise specifications without prior notice to supply the best product possible. For further information on this module or other SECO products, but also to get the required assistance for any and possible issues, please contact us using the dedicated web form available at http://www.seco.com (registration required).
Check carefully that all cables are correctly connected and that they are not damaged. 1.5 Electrostatic discharges The SBC-D23 board, like any other electronic product, is an electrostatic sensitive device: high voltages caused by static electricity could damage some or all the devices and/or components on-board.
Page 14
The SBC-D23 board offers two USB 2.0 standard Type-A connectors; another USB interface can be available, as a factory alternative, on an internal header or on the LVDS connector. The USB OTG interface is available both on a micro-B connector (client mode) an on an additional Type-A connector. Finally, an additional USB header is available, managed by the on-board microcontroller.
Supported Operating Systems: Linux Yocto 3 x USB 2.0 Host ports on standard Type-A slots USB recovery internal connector ** Measured at any point of SECO standard heatsink for this product, during any and all times (including start-up). Actual temperature will widely depend Audio on application, enclosure and/or environment.
2.3.1 UPS By-pass connector The SBC-D23 board allow the possibility of connecting external UPS modules able to supply a 12V Backup, to be used in case that the main power supply is not available For this kind of connection, it is provided a standard Micro-fit 2x7 connector UPS By-Pass Connector type Molex 43045-1412 or equivalent, with the pinout shown in the table on the left.
Batteries supplied with SD23 are compliant to requirements of European Directive 2006/66/EC regarding batteries and accumulators. When putting out of order SBC-D23, remove the batteries from the board in order to collect and dispose them according to the requirement of the same European Directive above mentioned.
Page 23
3.1 Introduction On SBC-D23 board, there are several connectors located on the lower plane. Standard connectors are placed on the same side of PCB, so that it is possible to place them on a panel of an eventual enclosure. Please be aware that, depending on the configuration purchased, the appearance of the board could be different from the following pictures.
When using SBC-D23 boards, it is necessary to consider carefully the heat generated by the module in the assembled final system, and the scenario of utilization. Until the board is used on a laboratory shelf, on free air, just for software development and system tuning, then a heatsink with integrated fan could be sufficient for board’s cooling.