Page 1
LEVY SMARC Rel. 2.1.1 compliant module with NXP i.MX 8M Plus Applications Processors...
Page 2
SECO S.p.A. reserves the right to change precise specifications without prior notice to supply the best product possible. For further information on this module or other SECO products, but also to get the required assistance for any and possible issues, please contact us using the dedicated web form available at http://www.seco.com (registration required).
5.1 Drive soldered on-board, up to 64GB Linux 64-bit SD 1-bit/4-bit SDIO 3.0 interface ** Measured at any point of SECO standard heatspreader for this product, PCI Express during any and all times (including start-up). Actual temperature will widely Up to 1 x PCI-e x1 Gen3 port depend on application, enclosure and/or environment.
2.3 Electrical Specifications According to SMARC specifications, the LEVY module needs to be supplied only with an external +5V power supply. For Real Time Clock working and CMOS memory data retention, it is also needed a backup battery voltage. All these voltages are supplied directly through card edge fingers (see connector’s pinout).
Linux SECO will offer the BSP (Board Support Package) for these O.Ss, to reduce at minimum SW development of the board, supplying all the drivers and libraries needed for use both with the SMARC board and the Carrier Board, assuming that the Carrier Board is designed following SECO SMARC Design Guide, with the same IC’s.
Page 27
The customer acknowledges and agrees to the conditions set forth that these schematics are provided only as an example and that he will conduct an independent analysis and exercise judgment in the use of any and all material. SECO declines all and any liability for use of this oduct design 3.2.2.1 LCD Display Support Signals...