Step 15 Setting The Indoor Unit Addresses And The Installation Options - Samsung AC BNADCH Series Installation Manual

Indoor Unit Installation
Step 15 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and the
installation options in a batch: set both of them respectively.
Common steps for setting the addresses and
options
Entering mode for
setting option
High Temp Button
Low Temp Button
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control, and
then insert them again.
b While holding down the
Temp) buttons simultaneously, insert the batteries
into the remote control.
c Make sure that you are entered to the mode for
setting the options:
18 English
2
•
•
•
Option setting
mode
Mode change
High Fan Button
Low Fan Button
(High Temp) and (Low
Set the option values.
CAUTION
The total number of available options are 24: SEG1 to
SEG24.
Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
Set a 2-digit value for each option pair in the following
order: SEG2 and SEG3 → SEG4 and SEG5 → SEG6 and
SEG8 → SEG9 and SEG10 → SEG11 and SEG12 → SEG14
and SEG15 → SEG16 and SEG17 → SEG18 and SEG20 →
SEG21 and SEG22 → SEG23 and SEG24
SEG1 SEG2 SEG3
0 X X
SEG7 SEG8 SEG9 SEG10
1 X X
SEG13 SEG14 SEG15 SEG16
2 X X
SEG19 SEG20 SEG21 SEG22
3 X X
On (SEG1 to SEG12)
SEG4 SEG5 SEG6
X X X
SEG11 SEG12
X X X
SEG17 SEG18
X X X
SEG23 SEG24
X X X
Off (SEG13 to SEG24)