Table of Contents
Advertisement
Safety Information
•
Excessive indoor humidity or clogged condensate
drain lines may cause water to drip from indoor units.
Do not install the indoor unit where dripping could
result in damage to property, such as above electronic
equipment or other sensitive instruments
•
Our units must be installed in compliance with the
spaces indicated in the installation manual to ensure
either accessibility from both sides or ability to
perform routine maintenance and repairs. The units'
components must be accessible and that can be
disassembled in conditions of complete safety either
for people or things. For this reason, where it is not
observed as indicated into the Installation Manual, the
cost necessary to reach and repair the unit (in safety,
as required by current regulations in force) with slings,
trucks, scaffolding or any other means of elevation
won't be considered in-warranty and charged to end
user.
Power supply line, fuse or circuit breaker
•
Always make sure that the power supply is compliant with
current safety standards. Always install the air conditioner
in compliance with current local safety standards.
•
Always verify that a suitable grounding connection is
available.
•
Verify that the voltage and frequency of the power supply
comply with the specifications and that the installed
power is sufficient to ensure the operation of any other
domestic appliance connected to the same electric lines.
•
Always verify that the cut-off and protection switches
are suitably dimensioned.
•
Verify that the air conditioner is connected to the power
supply in accordance with the instructions provided in
the wiring diagram included in the manual.
•
Always verify that electric connections (cable entry,
section of leads, protections...) are compliant with
the electric specifications and with the instructions
provided in the wiring scheme. Always verify that all
connections comply with the standards applicable to
the installation of air conditioners.
•
Be sure not to perform power cable modification,
extension wiring, and multiple wire connection.
‐
It may cause electric shock or fire due to poor
connection, poor insulation, or current limit override.
‐
When extension wiring is required due to power
line damage, refer to "Step 11 Optional: Extending
the power cable" in the installation manual.
4
English
CAUTION
•
Make sure that you earth the cables.
‐
Do not connect the earth wire to the gas pipe, water
pipe, lighting rod or telephone wire. If earthing is
not complete, electric shock or fire may occur.
•
Install the circuit breaker.
‐
If the circuit breaker is not installed, electric shock
or fire may occur.
•
Make sure that the condensed water dripping from the
drain hose runs out properly and safely.
•
Install the power cable and communication cable of
the indoor and outdoor unit at least 1m away from the
electric appliance.
•
Install the indoor unit away from lighting apparatus
using the ballast.
‐
If you use the wireless remote control, reception error
may occur due to the ballast of the lighting apparatus.
•
Do not install the air conditioner in following places.
‐
Place where there is mineral oil or arsenic acid.
Resin parts flame and the accessories may drop or
water may leak.
The capacity of the heat exchanger may reduce or
the air conditioner may be out of order.
‐
The place where corrosive gas such as sulfurous
acid gas generates from the vent pipe or air outlet.
The copper pipe or connection pipe may corrode
and refrigerant may leak.
‐
The place where there is a machine that generates
electromagnetic waves. The air conditioner may not
operate normally due to control system.
‐
The place where there is a danger of existing
combustible gas, carbon fiber or flammable dust.
The place where thinner or gasoline is handled.Gas
may leak and it may cause fire.
•
Please cover the air conditioner with PE BAG after
installation,and remove it when you start to run air
conditioner.
PE BAG
Advertisement
Table of Contents
