Sharp AR-M162 Operation Manual page 185

TRANSMISSION USING F-CODES
F-code confidential transmission
1
Follow steps 1 to 4 of "BASIC
PROCEDURE FOR SENDING FAXES"
(page 18) and then follow the steps
below.
2
Press the [SPECIAL FUNCTION] key.
When the [SPECIAL
2-SIDED
FUNCTION] key is pressed, the
COPY
SPECIAL FUNCTION
special function selection
DUPLEX SCAN
screen appears.
ACC.
3
Select "SENDING OPTIONS" with the
[ ] or [ ] key.
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
4
Press the [OK] key.
5
Select "SUB ADDRESS TX" with the
[ ] or [ ] key.
6
Press the [OK] key.
7
Enter the fax number of the other
machine with the numeric keys, or
press a Rapid key, or dial a Speed Dial
number (a group key cannot be used).
To clear a mistake when
entering a number with the
WXYZ
numeric keys, press the [C] key
to clear one digit at a time.
26 27 28 29
A B C
31 32 33 34
F G H
A destination selected with a Rapid key or Speed Dial
number is indicated by an icon and a number. To clear
an entry, press the [C] key.
56
SPECIAL FUNCTION
FAX PRINT HOLD
TIMER MODE
SENDING OPTIONS
SENDING OPTIONS
SERIAL POLLING
SUB ADDRESS TX
SUB ADD POLLING
8
Press the [OK] key.
9
Enter the sub-address (maximum 20
digits) with the numeric keys.
WXYZ
• Characters that can be entered are numbers, "#",
and spaces. However, the initial character cannot be
a space.
• If you make a mistake, press the [C] key and re-enter
the correct digit(s).
• If you specified a Rapid key or Speed Dial number in
step 7 that has a sub-address programmed, the
sub-address will appear. Go to the next step without
entering a sub-address.
10
Press the [OK] key.
11
Enter the passcode (maximum 20
digits) with the numeric keys.
WXYZ
• Characters that can be entered are numbers, "#",
and spaces. However, the initial character cannot be
a space.
• If you make a mistake, press the [C] key and re-enter
the correct digit(s).
• If you specified a Rapid key or Speed Dial number in
step 7 that has a passcode programmed, the
passcode will appear. Go to the next step without
entering the passcode.
12
Press the [OK] key.
13
Press the [START] key (
WXYZ
@.- _
READ-END
• Scanning begins.
• If you are scanning from the document glass and
have another page to scan, change pages and press
the [START] key ( ). Repeat until all pages have
been scanned and then press the
).
key.