Inspur 3008 Series Configuration Manual page 19

Logging in to the CU screen requires a server restart, which will cause system
service interruption.
Procedures:
1. Hard reset the server
Log in to the target server remotely via BMC and click Hard Reset in the remote
console, as shown below.
Figure 3-1 Hard Resetting the Server
During POST, when the prompt Press <Ctrl><C> to Start AVAGO Config Utility
2.
appears, press <Ctrl> and <C> to enter the SAS3008IR MPT3BIOS Config Utility
screen, as shown below.
Figure 3-2 Prompt on How to Start Config Utility
The Inspur SAS3008IR POST screen is shown below.
14