Installation In A Sliding Sash Window - Sharp CV -P09FX Installation And Operation Manual

INSTALL WINDOW PANEL

Installation in a sliding sash window

(See page 12 for installation in a double-hung window.)
1
Connect the rain guards to the insect
guard net.
Insert all three projections on each rain
guard into the holes in the insect guard net.
Side "A" will now be uppermost, as
indicated in the diagram.
2
Attach the guard combined above to the
window panel.
Push the insect guard net firmly to ensure
that its four projections fit into the holes in
the window panel.
Side "A" will now be at the top, as indicated
in the diagram, when it is installed in the
window.
3
Cut the foam seal A (adhesive type) to the
proper length and attach it to the window
frame.
4
Install the window panel into the window
frame.
If the inner height of the window is
between 22" (559mm) and 24" (609mm)
inclusive.
The window panel cannot be installed in
windows less than 22" (559mm) high, as
you will be unable to shut the exhaust
cover.
(1) Remove the adjustment panel from the
window panel, and cut the window panel
to the same height as the window.
(2) Open the window sash and place the
window panel on the window frame.
(3) Secure the window panel to the window
frame with 2 screws.
Insect guard net
Hole
Projection
Projection
Window
panel
Window
panel
E-14
"A"
Rain guard
Window panel
"A"
Foam seal A
(adhesive type)
Exhaust cover
Cut
Adjustment panel
22"~24"