Download Print this page

OLT SSGS812-FJ-Ply Assembly Manual page 30

8x12 sunshed greenhouse building fj bevel model with plywood roof

Advertisement

69.
Align and attach both Narrow and Wide
Trims in each corner. Starting with a Narrow
Trim (1/2" x 2 1/2" x (2 Short Wall @ 79") & (2 Tall
Wall @ 88")), align tight underneath Soffit and
Rafter. Position flush with Filler Trim so Wide
Trim will cap it when attached in Step 70. Use
8 - 1 1/2" finishing nails to secure. Note that
Narrow Trim will sit slightly below Bottom Skirting
when correctly attached.
70.
Position Wide Trim (1/2" x 4 1/2" x
(2 Short Wall @ 82") & (2 Tall Wall @ 87"))
over Filler Trim and to cap Narrow Trim. Align
Wide Trim at bottom with Narrow Trim so flush
with each other. Secure trim with 8 - 1 1/2"
finishing nails. Complete remaining corner trims.
Same vertical
height as Wide
Corner Trim.
71.
Position 2 Door Trims (2 @ 1/2" x 2 1/2" x 87") on each side of door opening. Right side will
sit flush with Door Jamb. Left side will sit flush on edge of Narrow wall. Attach with 8 - 1 1/2" finish-
ing nails. Do a dry run with the Horizontal Gable Trim (Step 86 & 87) to confirm vertical location of
Trims. Next, position Triangular Gable Trim over exposed cavity of Gable Wall on Long Roof Side.
Use 2 finishing nails to secure into rafter. Complete for both front and rear Gables.
Important - Gable Trim will be found stapled in the corners on inside of gables.
Toll Free 1-888-658-1658
Note: Triangular
Gable Trim is
located inside
gable corner
behind scrap
piece marked
with "X"
www.outdoorlivingtoday.com
Page 30
Triangular
Gable Trim
sales@outdoorlivingtoday.com

Advertisement

loading