Advertisement
Confirm 32"
wide Door
Opening at
bottom.
29.
When all walls are attached together, check alignment with
the floor. Bottom wall framing should sit flush with outside of floor
frame. When positioned correctly, fasten bottom wall plates to floor
using 4 - 2 1/2" screws per wall panel.
Important: If walls are not lining up and appear higher or lower
than each other, your floor may not be LEVEL. Please check the
level of your floor. You may need to make slight adjustments to
level your floor before proceeding.
30.
Locate and place Side Extendor Walls on top of Side Walls in rear corner. Align so 2x3
framing lines up with framing of regular walls. When correctly in place, secure with 3 - 2 1/2" screws
per piece.
Toll Free 1-888-658-1658
Optional:
Caulking seams will help
prevent moisture from entering. Caulking is
included to complete Polygal Windows
only. Additional Caulking may be required.
www.outdoorlivingtoday.com
Advice: Prior to fastening walls and
installing rafters, take time to confirm your
walls are level, square and plumb.
Measure diagonal at top and bottom of
walls corner-to-corner. This should be
approximately 159 3/4". More importantly, if
measurements are not within 1/4", your
walls are not square. Adjusting now will
make it easier to the roof section later
Bevel Siding of
Extender Wall will
overlap Wall Panel
Page 16
Angle
screws into perimeter
Floor Joists.
sales@outdoorlivingtoday.com
.
Advertisement
