Table of Contents
Advertisement
Electric dispenser EWL 15, 30
A 10 Operating Faults
Repairs and servicing work on the
electrical part of this equipment must
only be undertaken by experts or by persons
trained in our factory who are aware of the
safety regulations. Disconnect the mains
plug from the power supply, resp. switch
off the disconnecting switch before opening
any part of the equipment.
Too little plaster flows from the electric-
dispenser:
Possible cause
a) Clamp coupling » blocked or deformed.
b) Plaster sticking due to dampness (lumpy).
c) Plaster has become compressed on filling
the container.
d) Electromagnet £ or micro-switch for
electro-magnet £ defective.
Remedy
a) Clean clamp coupling » and replace if
necessary.
b) Replace plaster.
c) Loosen plaster by stirring.
d) Replace electromagnet £ and/or micro
switch in the holder of the electro-magnet
®.
9
Advertisement
Table of Contents
