Monitoring Your Server - BITMAIN T19 Hydro Server Installation Manual

4.

Monitoring Your Server

To check the operating status of your server (taking T19 Hydro 138.5T as an example):
Click dashboard marked below to check the server status.
1.
Note: The frequency of T19 Hydro server is fixed with the value 550 MHz. Firmware will stop running when
the Temp (PCB) reaches to 80℃ or the water temperature is either greater than 65℃ or lower than 20℃，
there will be an error message "Fatal Error: Temperature is too high!" shown on the Bottom of the Kernel log
page.
2. Monitor your server according to the descriptions in the following table:
Option
Number of chips
Frequency
Real Hashrate
Inlet Temp
Outlet Temp
Chip state
Number of chips detected in the chain.
ASIC frequency setting.
Real-time Hashrate of each hash board (GH/s).
Temperature of the inlet (°C).
Temperature of the outlet (°C).
One of the following statuses will appear:
●
The Green Icon - indicates normal
●
The Red Icon- indicates abnormal
- 12 -
T19 Hydro Server Installation Guide
Description
4. Monitoring Your Server