Monitoring Your Server - BITMAIN ANTMINER D3 Installation Manual

5. Monitoring Your Server

To check the operating status of your server:
1. Click the status marked below.
2. Monitor your server according to the descriptions in the following table:
Option
ASIC# Number of chips detected in the chain.
Frequency ASIC frequency setting.
GH/S(RT) Hash rate of each hash board ( GH/s)
Temperature of each hash board (°C).(Applied only to server with fixed frequency)
Temp(PCB)
Temp(Chip) Temperature of the chips on each hash board (°C).
ASIC status One of the following statuses will appear:
●
●
●
Note: The D3 server will stop running when the Temp(PCB) exceeds to 85°C, there will be an
error message "Fatal Error: Temperature is too high!" shown in the bottom of kernel log page.
O - indicates OK
X - indicates error
- - indicates dead
- 13 -
D3 Server Installation Guide
5. Monitoring Your Server
Description