Input Source Selection (Rgb Scart 21-Pin) - Sanyo PJLINK PLC-XL51 Owner's Manual

Video Input

Input Source Selection (RGB Scart 21-pin)

Direct Operation
Press the INPUT button on the top control or COMPUTER 1
button on the remote control to select Computer 1.
Before using INPUT or COMPUTER 1 buttons, select the
correct input source through Menu operation as described
below.
Menu Operation
1
Use the MENU button to display the On-Screen Menu.
Press the Point
pointer to the Input Menu icon.
2
Use the Point
pointer to Computer 1 and then press the SELECT
button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to RGB (Scart) and then press the
SELECT button.
When the input source is coming from
RGB (Scart)
video equipment connected to the
COMPUTER IN 1 terminal with a Scart-VGA
Cable (not supplied), select RGB (Scart).
✔Note:
•Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is set as Monitor out (p.49).
•Computer 2 (COMPUTER IN 2/MONITOR OUT) can
accept only RGB signal.
• Wired and Wireless are for the Network function. See
owner's manual "Network Set-up and Operation" .
38
buttons to move the red frame
7 8
buttons to move the red arrow
ed
Top Control
INPUT button
Remote Control
COMPUTER 1 button
*See Note at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB (Scart)
and press the SELECT button.
INPUT button
Computer 1
Computer 2*
Video
Wired
Wireless