Sanyo PJLINK PLC-XL51 Owner's Manual page 58

Sanyo projector user manual
Hide thumbs Also See for PJLINK PLC-XL51:
Table of Contents

Advertisement

Antitheft Alarm Function
Charge the built-in battery pack
As long as the AC power cord is connected, the built-in
battery for Alarm function is being charged at all times.
While charging the battery, "Charging" is displayed in the
menu.
The "Charging" appears dimmed when the battery is fully
charged or if charging malfunction occurs.
Replace the rechargeable battery pack
Use only the specified battery for this projector. Using other
types of battery may cause accident or fire hazard.
Replacement Battery: SANYO Ni-MH BATTERY PACK
How to replace the rechargeable battery pack
1
Unplug the AC power cord from a wall outlet.
2
Set the Alarm function to "Off" (see page 56). If it is
not released, the alarm will start ringing when you try
to remove the rechargeable battery cover.
3
Remove the screw from the rechargeable battery
cover and open the cover.
4
Pull out the battery connector and remove the battery.
Install new battery and plug the connector into the
5
socket.
Note: The battery connector has polarity. Observe
battery polarity when installing.
6
Put back the battery cover and secure it with the
screw.
Caution: Tighten the screw securely. If you fail to do
so, the alarm will not operate. Do not use any
other screws. This may cause damage to the
projector.
✔Note:
• The PIN code and settings you have changed are
effective even after the battery is changed.
•When replacing the rechargeable battery pack, protect
the infrared remote receiver with a soft cloth to avoid
damaging it.
•Unplug the battery connector if you carry your
projector frequently and use the carrying case. If you
do not unplug the battery connector, the alarm may
be triggered when the Alarm buttons are accidentally
pressed inside the carrying case.
• The built-in battery pack is a consumable supply. Each
time you repeat discharge and recharge the battery,
the battery life will decrease. The battery will gradually
discharge when left for long periods even without use.
If the full-charged battery is left at normal temperature
of 95º F (25º C), the battery will gradually discharge and
can be non-rechargeable after about 7 months. The
battery life may vary from battery to battery according
to the environment of use.
58
Part No. 645 089 8587
Screw
Remove the screw and
open the battery cover.
Install the battery, then put back the battery cover
and secure it with the screw.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plc-xl51 - 2700 lumensPlc-xl51

Table of Contents