Connecting Projector; Terminals Of Projector - Sanyo PLV-HD2000E Owner's Manual

CONNECTING PROJECTOR

This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity of signals from
computers and video equipment. 4-built-in Terminal Slots enable you to arrange desired combinations of input sources just
by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.
REPLACEMENT OF TERMINAL
NOTE; When replacement of terminal board, MAIN
ON/OFF switch should be OFF position.
1 Remove 2 Screws on terminal.
2 Pull out terminal by holding handle.
3 Replace terminal. Insert terminal along Guide to fit Plug
into Socket.
4 Tighten screws to secure terminal.
NOTES ON ORDERING OR USING
OPTIONAL INTERFACE BOARD
When ordering or using Optional Interface Board
(Terminal Board), contact your sales dealer. When con-
tacting the sales dealer, tell the Optional Control
Number (Op.cont.No.) in the menu that is located under
Language Select Menu. (See page 38.)
12

TERMINALS OF PROJECTOR

3 TERMINAL SLOTS (Factory set)
SERIAL PORT IN
SERIAL PORT OUT
R/C JACK
AUDIO OUT
R
INPUT/OUTPUT
TERMINALS
OUT
IN LINK A IN
AUDIO
R/Pr G/Y B/Pb H/HV V
R
USB AUDIO
DVI
R
L
RESET
(MONO)
Figure shows DVI terminal.
Plug
LINK B OUT DUAL-LINK
SDI Terminal
CONTROL PORT
L
5 BNC Terminal
(MONO)
CONTROL PORT
L
DVI Terminal
(MONO)
Screws
Guide
Socket