Connecting Projector; Terminals Of Projector - Sanyo PLC-SE15 Owner's Manual

CONNECTING PROJECTOR

This projector has input and output terminals on its back for connecting computers and video equipment. Refer to figures on
pages 11 to 13 and connect properly.
S-VIDEO INPUT JACK
Connect the S-VIDEO
output from video
equipment to this
jack. (Refer to P13.)
COMPUTER IN 1
DVI - I
R – AUDIO IN – L
S – VIDEO
COMPUTER INPUT / MONITOR
OUTPUT TERMINAL
This terminal is switchable and
can be used as computer input
or monitor output. Set the
terminal up as either Computer
input or Monitor output properly
before using this terminal.
(Refer to P12, 36.)
Note:This terminal outputs
analog
COMPUTER IN 1 DVI-I
terminal only.
COMPUTER INPUT
(DIGITAL/ANALOG)
Connect
output (Digital / Analog
DVI-I type) to this
terminal. (Refer to P12.)

TERMINALS OF PROJECTOR

AUDIO INPUT JACKS
Connect the audio output
from video equipment to
these jacks.
(Refer to P13.)
G When the audio output
is monaural, connect it
to L (MONO) jack.
VIDEO
(MONO) Y – Pb / Cb – Pr / Cr
AUDIO IN
R – AUDIO OUT
COMPUTER
COMPUTER IN 2 /
MONITOR OUT
USB
signal from
computer
VIDEO INPUT JACKS
Connect the composite video
output from video equipment
to VIDEO/Y jack or connect
the component video outputs
to VIDEO/Y, Pb/Cb and
Pr/Cr jacks. (Refer to P13.)
– L
RESET
CONTROL PORT
COMPUTER AUDIO
INPUT JACK
Connect the audio output
(stereo) from computer to
this jack. (Refer to P12.)
AUDIO OUTPUT JACKS
Connect an external
audio amplifier to these
jacks.
(Refer to P12, 13.)
RESET BUTTON
This projector uses a micro
processor to control this unit,
and occasionally, this micro
processor may malfunction
and need to be reset. This
can be done by pressing
RESET button with a pen,
which will shut down and
restart the unit. Do not use
RESET function excessively.
CONTROL PORT CONNECTOR
When controlling the computer
with Remote Control of this
projector, connect the mouse
port of your personal computer
to this connector. (Refer to
P12.)
USB CONNECTOR (Series B)
When controlling the computer
with Remote Control of this
projector, connect USB port of
your personal computer to this
connector. (Refer to P12.)
11