Table of Contents
Advertisement
CONNECTING THE COMPUTER
CONNECTING TO THE COMPUTER INPUT HDB15-PIN (VGA) TERMINALS (1 and 2)
Personal computers can be connected to the HDB15-pin (VGA) terminal on the projector.
. Connect the computer to these terminals using the VGA cable and VGA/MAC adapter (provided).
CONNECTING TO THE MONITOR OUTPUT HDB15-PIN (VGA) TERMINAL
This terminal contain the information that is viewed on the screen.
Monitor can be connected to the HDB15pin (VGA) terminal on the projector.
l
Connect the monitor to this terminal using the monitor cable (not provided).
TERMINAL
CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (1 and 2)
l
Connect audio outputs from your computer to these jacks using the audio cable (not provided).
CONNECTING TO THE MULTI-POLE 12-PIN (CONTROL PORT) CONNECTORS (1 and 2)
. If you wish to control the computer with projector's remote control unit, you must connect control port (PS/2, Serial or
ADB port) on your computer to projector's control port with cable. (three type cables provided)
n
CONTROL PORT
7 4
The RxD port (5 pin on the Serial Port) is provided on control port 2 connector only. If you control the projector
by computer, you must connect control port 2 connector.
CONNECTING THE PROJECTOR
Pin No./Signal
Red input
Green input
Blue input
Sense 2
Ground (Horiz. sync.)
Ground (Red)
Ground (Green)
Ground (Blue)
CONTROL PORT CABLE
REMOVAL HINT
Disconnect control port cable
with following steps.
connector with one hand.
2.
Pull the portion (B) arrow
direction and remove
connector.
Pin No./Signal
9 Non Connect
10 Ground (Vet-t. sync.)
11 Sense 0
12 Sense 1
13 Horiz. sync.
14 Vert. sync.
15 Reserved
1
B
Advertisement
Table of Contents
