Lamp Replacement - Sanyo PLV-HD2000E Owner's Manual

APPENDIX
When the life of the Projection Lamp of this projector draws to an end,
the LAMP REPLACE indicator lights yellow. If this indicator lights
yellow, replace the projection lamp with a new one promptly.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER.
Allow a projector to cool, for at least 45 minutes before
you open Lamp Cover. The inside of a projector can
become very hot.
Follow these steps to replace lamp assembly.
1
Check number of lamp to be replaced on Lamp Status Display.
Turn off a projector and disconnect AC Power Cord. Allow a
2
projector to cool down for at least 45 minutes.
3
Remove two screws on Lamp Cover and press button to open
Lamp Cover. (See right figure.)
4
Loosen two screws and pull out Lamp Assembly to be replaced
by grasping handle.
5
Replace Lamp Assembly with a new one and tighten two screws.
Make sure Lamp is set properly
6
Replace Lamp Cover and tighten two screws.
7 Connect AC Power Cord to a projector and turn a projector on.
8 Reset Lamp Replacement Counter. (Refer to section "Lamp
counter reset" on page 41.)
NOTE : Do not reset LAMP REPLACEMENT COUNTER when
lamp is not replaced.
CAUTION : DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAY
RESULT IN MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS.
NOTES ON LAMP REPLACEMENT
To maintain quality of picture (better balance of color and brightness in entire screen), we recommend replacing
all 4 lamps at a time.
44

LAMP REPLACEMENT

FRONT INDICATORS
WARNING
TEMP.
LAMP
REPLACE
For continued safety, replace with a lamp assembly of
the same type.
Do not drop a lamp assembly or touch a glass bulb! The
glass can shatter and may cause injury.
REAR INDICATORS
LAMP
READY
LAMP REPLACE
INDICATOR
CAUTION
LAMP
COVER
SCREWS
LAMP 1
Make sure which number of lamp needs to be
replaced on Lamp Status Display.
Figure shows case of replacing LAMP 2.
BUTTON
SCREWS
LAMP 3
LAMP 4
LAMP 2