ICP DAS USA DGW-521 User Manual page 24

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru
Command
%AANNTTCCFF !AA
$AA2 !AANNTTCCFF Reads the Module Configuration
$AA5 !AAS
$AAF !AA(Data)
$AAM !AA(Data)
$AAP !AASC
$AAPN !AA
~AAO(Name) !AA
~AARD !AAVV
~AARDVV !AA
Command
@AADCiddcc !AA
@AADE !AAhh
@AADF !AAs
@AADF1 !AA
@AADN !AAnnss
24
General Command Sets
Response
Set Module Configuration
Reads the Reset Status
Reads the Firmware Version
Reads the Module Name
Reads the Protocol
Sets the Protocol, N=0 for DCON protocol, 1
for Modbus RTU protocol
Sets the Module Name
Reads the response delay time, VV in hex
format
Sets the response delay time, VV = 00 ~ 1E
in hex format
DALI Command Sets
Response
Sends DALI command, i: command index, 0
~ 7, dd: command address in hex, cc:
command data in hex
Gets the execution status of the DALI
commands, hh in hex, each bit for each
command and the value is 1 for command
finished and 0 for command not finished or
no command executed
Gets the status of finding all DALI devices, s
is 0 for finished and 1 for finding
Finds all of the DALI devices connected on
the DALI bus
Gets the status of address allocation, nn is the
number of addresses allocated in hex,
ss is the allocation status
00: no allocation command
01: finished
02: allocating
03: old address not available
04: invalid address data
05: too many addresses to be allocated
DGW-521 User Manual, Rev. A1.0
Description
Description