Table of Contents
Advertisement
M A I N T E N A N C E G U I D E L I N E S
DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE!
FUSE REPLACEMENT
Disconnect the unit from its power source. Remove the power cord from the unit. Once the cord has
been removed, use a flat-head screw driver to unscrew the fuse holder. Remove the bad fuse and
replace it with a new one.
TROUBLESHOOTING
Unit not responding to DMX:
•
Check that the DMX cables are connected properly and are wired correctly (pin 3 is "hot"; on some
other DMX devices, pin 2 may be 'hot'). Also, check that all cables are connected to the right
connectors; it does matter which direction the inputs and outputs are connected.
CLEANING
Frequent cleaning is recommended to ensure proper function, optimized light output, and an extended
life. The frequency of cleaning depends on the environment in which the fixture operates: damp, smoky,
or particularly dirty environments can cause greater accumulation of dirt on the fixture's optics. Clean
the external lens surface periodically with a soft cloth to avoid dirt/debris accumulation.
NEVER use alcohol, solvents, or ammonia-based cleaners.
MAINTENANCE
Regular inspections are recommended to ensure proper function and extended life.
There are no user serviceable parts inside this fixture, please refer all other service issues to an
authorized ADJ service technician. Should you need any spare parts, please order genuine parts from
your local ADJ dealer.
Please refer to the following points during routine inspections:
-
A detailed electrical check by an approved electrical engineer every three months, to make sure the
circuit contacts are in good condition in order to prevent overheating.
-
Be sure all screws and fasteners are securely tightened at all times. Loose screws may fall out
during normal operation, resulting in damage or injury as larger parts could fall.
-
Check for any deformations on the housing, color lenses, rigging hardware, and rigging points
(ceiling, suspension, trussing). Deformations in the housing could allow for dust or liquids to enter
into the fixture. Damaged rigging points or unsecured rigging could cause fixture to fall and seriously
injure a person(s).
-
Electric power supply cables must not show any damage, material fatigue, or sediments.
NEVER remove the ground prong from the power cable.
-
8
Advertisement
Table of Contents
