Bosch Zamo Original Instructions Manual page 38

38 | English
– Pull the tape (13) out of the adapter by the contact edge
(14) and place the tape against the object to be measured.
The visible length of tape (between the two red markings)
corresponds to the measurement length (in cm).
– Press the measuring button (1) to save the measured value.
The current measured value (g) is shown on the bottom line
of the display.
Press the measuring button (1) again to start a new meas-
urement. The current measured value (g) is shown on the
bottom line of the display, while the previous measured
value (e) is saved and shown on the top line of the display.
Note: When switching off the measuring tool, the current
measured value (g) is reset to "0", even if the tape is still
pulled out. To avoid measuring errors, always retract the tape
fully before taking a new measurement. Do not press the
measuring button until you have done this.
If the tape is already extended when you are fitting the adapter
to the measuring tool or switching on the measuring tool, the
"roll in" indicator will appear on the display. Retract the tape
fully and press the measuring button before taking a new
measurement.
Always make sure that the measuring tape does not
u
snap back into the adapter. Release the tape slowly back
into the adapter; otherwise it may become damaged.
Area measurement
– Press the measuring button (1) twice in quick succession to
multiply the last two measurements together. The indicator
(h) appears on the display and the area measurement is
shown.
1 609 92A 7L5 | (05.05.2022) Bosch Power Tools